Ring Size Guide

My Ring Size

Method 1

How to Measure an Existing Ring

1. Choose the Right Ring

  • Select a ring that fits the finger where you plan to wear your Margot Georgia Jewellery ring.

2. Measure the Inner Diameter

  • Place the ring on a flat surface.
  • Use a ruler or measuring tape to measure the internal diameter of the ring in millimetres (mm).
  • Ensure the measurement starts at the 0mm mark for accuracy.

    3. Note Your Measurement

    4. Record the measurement in millimetres, as precision is key.

    5. Find Your Size

    • Refer to the size chart below to determine your perfect ring size.

    Method 2

    To determine your ring size follow these steps:

    Cut a strip of paper about 1cm wide.

    Wrap the paper strip around the finger you want to measure, just below the knuckle leaving space to slide the ring  over your knuckle. Make sure it's snug but not too tight.

    Mark the point where the paper strip overlaps.

    Unwrap the paper and measure the length from the starting edge to the marked point in millimetres (mm). This is the circumference of your finger.

    Refer to the chart below to determine your ring size.

    As a rule of thumb, you will probably need a slightly bigger size if the ring is wide. If the ring is sleek and slim we recommend that you opt for a slightly smaller size e.g. 0.5 size difference.

    This method can be used to find the ring size of any of your fingers. Choose the size that is closest to the measured length in millimetres. If your measurement falls between two sizes, it's generally recommended to choose the larger size for comfort. Keep in mind that wider rings require a slightly larger size.